Network Security

New install of 3140. I already have CAM setup and now setting up CAS in OOB VG. Just want to make sure as cco doc statest E0 is trusted and E1 is non-trusted. However, 3140 has physical E1 and E2 interface. 1. Can I assume that physical E1 is actuall...

From behind an ASA 5510 with 8.0.3 running, I can't establish and FTP connection to any server, either active or passive. It seems to die at getting the directory list. It can connect and verify username and password, then just sits for a minute then...

Hello,I use 5505 as PPPoE client in small office and everything works fine during weekdays,people browsing and accessing remote VPN from outside.Some time at mid-weekend ASA becomes not accessible for VPN/ping/ASDM,I assume that PPPoE session expires...

Hi,I have managed to get Cisco Client VPN's and a Site-to-Site office VPN (Cisco 877) onto my Cisco ASA and all working, until I issued the "no sysopt connection permit-vpn" command. This stops VPN traffic from being exempt from access-lists.I want ...

Hi guys,Could anyone please help me out with the configuration to meet the following requirement?I have one MPLS link which is terminating on the MPLS router and from there I am connecting my ASA Firewall. My inside Network is 192.168.12.0/24. I have...

up anyone know the cmd line to back up my pix to a tftp server...

Our primary unit failed over yesterday stating communication failure, but I want to failback. I used the failover active command, but I'm assuming that is not going to work since failover seems to be 'off'.FW-IN01# sh failoverFailover OffFailover un...

I am trying to get isakmp/ipsec to work between two Cisco routers. One router has a static public IP, the other router is on a 1-1 NAT behind an ASA5510. The 5510 is using standard Fe0/0 for outside and Fe1/0 inside. I have allowed all of the neede...

Hi I'm trying to add downloadable ACL's via a LDAP map. I have done a map between the info attribute in Microsoft ActiveDirectory and the Cisco-AV-Pair field.My problem is that when I add two lines in the configuration i recive an error in the ASA lo...

Dear All ,I have two ASA's connected in a failover mode .The issue is that when the inside -switch 1 goes down active ASA (ASA-A ) is not coming to standby mode. On the active ASA , I have made the configuration to monitor both inside and outside ...

im trying to access the ASA 5520 and getting the attached error ? any clues ? . I can telnet to the ASA without any issue . before i was able to access to ASA from same PC without any issues

Hi,Does the Pix have a setting as to what ICMP/Ping packets size it will permit to pass ? If so how is this configured ?Thanks