Network Security

I am trying to set up static single (1) and range (2) port forwarding on PIX 506E device using the following commands; however it is not working. What am I missing?Single Port Forwarding 1. static (inside,outside) tcp 24.172.x.x 5631 192.168.1.215 5...

Hi Guys,Picture the scene, customer has two ASA5510-BUN-K9. They do not have Security Plus license that is required for A/A HA.In order to enable this, is it simply a software upgrade or is another license required? Seems like a daft question but it'...

According to Bryan from Cisco System TAC:Step 1: Launch ASDMStep 2: Click on the Configuration button at the top of the pageStep 3: Click on the Security Policy button on the left.Step 4: Click on the Service Policy Rules TabStep 5: If you don't have...

Linux_FTP_Server---(DMZ)Pix(ExTERNAL)---Linux_FTP_clientPix is running version 7.2(2). DB has priority of 70. EXTERNAL has priority of 0.Pix DB interface IP is 10.102.160.19/28Pix EXTERNAL interface IP is 192.168.1.4/24Linux_FTP_Server is 10.102.16...

i need to config ipsec site-site vpn betweent cisco 3745 router and watchguard firebox700.after configuration, i check the phaseI between 3745 and firebox700 already setting up,C3745 gives log below:Feb 25 2007 08:25:29: %CRYPTO-6-IKMP_MODE_FAILURE: ...

Hello,Is it possible to configure the ASA5520 to support both easy and site-to-site VPN on the same outside interface!!!!incase your answer is YES.. how could we do it !!Regards,

Hello, I work with a software company. We currently have 160 user's. We have > Cisco 515e Firewall ( We dont have failover firewall ) Cisco 1841 Router 3 COM layer II switches 1 quantity of Cisco catalyst 3560 layer III switch 1 linux running prox...

Hi,configured ASA for allowing ftp requests to my ftp server residing behind the ASA,problem is when a internet client is doing ftp to the ftp server, he can able to connect, but he can't able to transfer the files after few seconds i get a message d...

Hi,I am implementing ASA's with SSM modules and I wanted confirmation that they can inspect http and block embedded traffic such as Internet Radio from being tunnelled through HTTP.The Cisco documentation hints at this, but I would like confirmation....

Hi There,I have configured site-to-site VPN between PIX and Juniper FW; I am checking the VPN link status and it is showing as up when monitoring via ASDM, however I cannot ping or access to the remote site. I am already having 2 ACLs allowing traffi...

hi there,I have an ASA 5520 (IOS 7.1) installed on my network.We have patted the inside network to the outside interface,thru which i am able to acces my web based mails on yahoo and few other domains.The problem i am facing is,while sending or reply...

I can't figure out for the life of me what is going on. This has been happening several a day this week.Everything will be fine and all the sudden the ACT and NET lights go out and connection is dropped. I cannot log back into the firewall. The only ...

hello all,i have a problem with ebgp with md5 through pix7.1.as you know, to pass bgp with md5 traffic for the pix6.3, i should configure a special configuraiton. it's norandom sequence number at the static nat configuraiton.static (i,o) 1.1.1.1 1.1....

Hi all,I've configured an ASA5510 for vpn access both from the internet and from a wireless lan on the same device.However I've got two different crypto maps, each one applied to a different interface of the asa, and two tunnel groups for the two gro...