Network Security

I have two related questions to SNMP set support on version 5.x of the IPS sensors:1) Is it possible to enable gets but not sets? There is just one configuration setting (enable-set-get to true or false). The docs allude to the default SNMP RW commu...

The IOS IPS keeps failing. For some reason it sends the alerts to MARS and then all of a sudden the IPS is disabled on the interface. This config. was down through SDM.

i can't find any document showing the memory capacity of the cisco ips 4250 and any upgrading capabilities

Hi,,I am having pix 515E with 7.0.2 os. I configured policy based nat and applied on the nat (inside) 1 access-list (access-list name)with global (outside) 1 interface command. The network diagram as follows.L3 switch-->pix 515E--->router 1700In L3 i...

after an password recovery the pix is not using the startup-config anymore. The running-config is taken from an other file which i dont know.Write mem command does add changes to the startup-config but after power off/on the running-config is again t...

Hi,I'm trying to configure a Pix 506E for a single network to allow RDP to the server. The Pix outside interface is a public IP that conects to a router managed by AT&T. The Ip address is 12.146.x.x. The inside interface is set to 192.168.1.1. To all...

Hi am running a pix 506 3.6(3) to gain Internet access to my remote office users. And in the same time users are connected to the main office via Lan –to Lan ipsec tunnel. The pix is connected to the Internet with ADSL line (ISP). The pix is also dis...

I've scoured the Cisco site and could not find the tool to migrate PIX to ASA. I have a 515E (6.30 code) and I want to use the "migration tool" to do the migration to an ASA 5520. Is there such a thing? Thanks,Damien

We use VMS 2.3 with RME 3.5. For RME no support for 876 routers is available. Will there be a IDU Upgrade file for the RME 3.5 that covers the 876 in the near future?

After upgrade to PIX 7.1.1, some reason PIX freeze the traffic for at least 5min when very large amount of data going from inside interface to DMZ interface. However, DMZ interface has VLAN configure. Did any of you come of cross this problem.Any he...

I have a IDS sensor running 3.1 version of soft ware. I also have a upgrade / recovery cd for version 4.1.When i load the cd & boot the machine it stops the installation & starts looking for a system file. Is it possible to upgrade from 3.1 to 4.1 st...

I have a 2000 server that offers MRI images to remote clients. From this site I have a vpn useing a pix at the remote.Telnet, Ping, and http works, sending images does not, I suspect this is an MTU issue, do I need to change the MTU at both the host...