Network Security

Have an edge router "outside" of the PIX, and a TFTP server "inside" the PIX, but when I TFTP the running config from the edge router to the server, the file shows up for a few seconds and then goes to a size of zero. I can TFTP from devices inside ...

how many "connections" should a PIX show for each host? I'm looking for a rough estimate of how many connections are normal per each host session.thanks,

Dear all,I am having difficulty of integrating NAC phase 2 with Tivoli TSCM. Anyone have the experience for this integration?Thanks.

i have the problem with to start the web interface (not start)

The vsat link between locationA to LocationB have been secured using ipsec. I have a problem printing across an ipsec-secured link. Every other traffic flows correctly but when i try printing from locationA to LocationB, only the first line prints. t...

I would like to change the MAC-Address of the Outside interface on PIX 501 but can't seem to find the command. Any idea?Thanks in advance!

I am configuring a pix 515e with 6 interfaces. Right now 3 are enabled, 0,1,4. I also have a 1760 router and a catalyst 1950 switch. the switch is configured in 4 vlans with vlan 1 ip 10.1.0.3 the router connection is on vlan 1 port 0/2. The pix is a...

Hi all, I've configured lac shaping for upload on my 2811 (ios xxx124-7.bin) as per:http://www.cisco.com/en/US/partner/products/ps6350/products_configuration_guide_chapter09186a0080455ade.htmlHowever it's not working. I suspect IOS fault, just wanted...

Hello I have a pix Cisco 515 with three interfaces. IP addresses are as follows: Inside : 10.10.10.1DMZ : 10.10.11.1Outside : 10.10.12.1The exchange server's address in local area network is: 10.10.10.200The SMTP mail relay server’s address in DMZ ...

All, I have set up a site to site VPN with a remote office, the remote office has a 501 and my site has a 515. The tunnel works fine, however my users in the remote office complain about the speed...we have a leased line of 2mb the remote site is in ...

I am currently in the process of configuring MARS to monitor two Cisco 4215 IPS sensors. I have rebuilt both of the sensors with the latest software (5.1d) and signatures and they are loggin events as expected.My question is, where is it best to fil...

Hello- I hv PIX 515E with 16MB flash,64MB RAM & VAC for which I am building failover.The failover bundle has come in with PIX515E-FO with 16MB flash,128MB RAM & VAC+.I understand both primary & secondary has to hv identical config for the failover to...

We have a 6509 running 12.2.18SXF with an IDSM-2 (5.0(6)). We are using VACLs to capture traffic from several VLANs onto the IDSM. Today, we added another VLAN to the IDSM by creating a VACL for that VLAN with the "action forward capture" statement. ...

My PIX-515 is working properly and has these files:Directory of flash:/6 -rw- 1726 13:19:48 Apr 07 2006 downgrade.cfg9 -rw- 1925176 13:20:16 Apr 07 2006 image_old.bin12 -rw- 5437440 14:03:23 Apr 07 2006 pix704.bin13...