I enabled IPS on a 2901 router. The signatures are uploaded and it is enabled on an interface. When I goto signatures I get a message box that says "You must first enable IPS before configuring signatures. To enable IPS, go to IPS Policies and enable IPS on any interface." Trouble is I do have IPS enabled.
Any Thoughts?
This is what was delivered to the router:
ip ips notify SDEE
ip ips name sdm_ips_rule
ip ips signature-category
category all
retired true
exit
category ios_ips advanced
retired false
exit
exit
interface GigabitEthernet0/1
ip ips sdm_ips_rule in
ip virtual-reassembly
exit
interface GigabitEthernet0/0
ip ips sdm_ips_rule in
ip virtual-reassembly
exit
interface Embedded-Service-Engine0/0
ip virtual-reassembly
exit
ip ips config location flash0:/IPS/