cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1432
Views
0
Helpful
1
Replies

Pix Device Manager

hperez
Level 1
Level 1

I have installed PDM 1.1(2) over six PIX 525, and I have configured nat 0. I was surprised PDM didn´t support nat 0 and static/conduit. Does anyone know if there is another release that supports these features?

Thanks in advance

1 Reply 1

ciscomoderator
Community Manager
Community Manager

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

Review Cisco Networking for a $25 gift card