2911 router sporadically looses a single address from the NAT configuration.
The router sporadically will loose a single NAT entry, it is always the same entry and will sometimes take a reload to add it back in. Once I get it back in I will save it to the router's start up config, but it never seems to stay. Any thoughts?
There are few interoperability issues between 2960x and other vendors.
In this article we will go over the steps on how to debug these issues.
Check the phy id from “show controllers ethernet-controller phy” output.
It appears that you are trying to access end of life information from
Cisco search. We have detected a problem with your script ("eol...) and
would like to help. Please contact firstname.lastname@example.org if you would
Cisco Licensing is pleased to announce the new Licensing Portal. It
provides customers with an enhanced self-service experience by
stream-lining and automating many licensing activities. Please take a
moment to familiarize yourself with the features that ...