It would be very helpful to have the ability to stage the OnPlus agents for deployment prior to arriving at a client site. By that I mean it would be helpful to have the ability to statically assign all the IP information, since we have clients that only use static IPs for security reasons, as well as update the appliance before sending it out. There are ways to work around this, but they are very tedious.
One piece of feedback on this is that OnPlus currently requires DHCP to Activate however it doesn't do a very good job of managing a DHCP environment wherein devices may regularly change IPs and OnPlus picks up and enters a duplicate device with the new IP and lists the old device as missing instead of merging/purging. So deployment to these static environments will actually have less challenges after deployment despite the fact that deployment itself is a challenge.
Please rate all helpful posts and mark correct answers to assist others searching for solutions in the community.
Dear OnPlus users,OnPlus Team is very excited to announce the
availability of OnPlus Mobile App, which will give you the ability to
access your customer accounts from wherever you are. Here are just some
of the features that are available with the OnPlus ...
QuestionsAccount Set UpHow can I add other users to my Cisco OnPlus
account? Record Creation No questions have been added yet.Activation and
InstallationWill I need one Cisco ON100 Network Agent for each customer
site? What are the differences between the...
The table below reflects Cisco products that have been tested and offer
enhanced support with Cisco OnPlus Service. In addition to the products
below, OnPlus Service can discover and monitor many other Cisco and 3rd
party devices. Links below point you to...