We're constanly adding in support for more devices and we are going to be focusing on additional Cisco 29xx and 35xx Catalyst platforms over the next few months. As of right now, the c2950 switch has not been fully qualified and tested. In my past experience, much of the OnPlus functionality should still be functional with some products that can leverage another tested platform's family. However, the config and firmware backup usually have to be developed on a per platform family basis.
I will take note of the error you are receiving above and pass it on to my device development team. We'll be sure to have this resolved and tested as we get these platforms supported.
Feel free to browse our currently supported devices at the link below:
Monitor Web Services on a Device on Cisco OnPlus Portal
Event Monitors are mainly used to monitor the device in order to provide notifications to the technicians in a timely manner if there are any problems with the device ...
Monitor Duplicate IP on OnPlus100
The Duplicate IP monitor is one of the event monitors on the OnPlus100 device to check the network performance. Duplicate IP monitor checks whether more than one device in the network uses ...
Monitor Host Performance with Internet Contol Message Protocol (ICMP) for a Device on Cisco OnPlus Portal
Event Monitors are mainly used to monitor the device in order to provide notifications to the technicians in a timely...