Depending on which release you are using, this is quite feasible. Command is RTRV-PM and the and
date is the beginning date of the PM or storage register period specified in "tmper". The format of "mondat" is "MM-DD", where MM (month of year) ranges from 1 to 12 and DD (day of month) ranges from 1 to 31. date is a Date. A null value defaults to "Current Date".
time is the beginning time of day of the PM or storage register period specified in "tmper". The format for "montm" is HH-MM, where HH (hour of day) ranges from 0 to 23 and MM (minute of hour) ranges from 0-59. time is a Time. A null value defaults to "Current Time".
I am still unable to retrieve historical PM data. Here is what the above referenced document says:
* is the access identifier. All the STS, VT1_5, FACILITY and DS1 AIDs are supported; is from the "ALL" section and must not be null
* indicates the location; valid values for are shown in the "LOCATION" section
* indicates the accumulation time period for the PM information; valid values for are shown in the "TMPER" section[/quote]
Table 4-95: TMPER Values
TMPER Values Description
Performance Parameter Accumulation Interval Length - Every 15 Minutes.
Performance Parameter Accumulation Interval Length - Every 24 Hours.[/quote]
The TMPER is not the time that you want performance monitoring from, it is the amount of time (15min or 1day) you want data from, as in "RTRV-PM-T1:TID:FAC-2-1:123::,,NEND,,15-MIN;", and the document is incorrect because the 454 actually won't take a dash in the TMPER.
I have been unsuccessful with the following formats:
Could someone from Cisco please tell me how historical PM data retrieval is done via TL1?
Fujitsu: rtrv-pm-aidtype:tid:aid:ctag::,,nend,rcv,1-day,,,1; (would get previous day's PM data...0 through 32 on a 15-min counter would get you anywhere between the current and up to 8 hours ago)
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.