I have a 15305 requirement to support DS3 to STM-1 conversion but my timing source is a T1 while the 15305 requires an E1. Any suggestions on how to resolve this? Any T1 to E1 timing conversion boxes out there?
Although each IP network is unique, the topologies and configurations presented in this chapter can be thought of basic building blocks, which can be combined together in order to apply them to a specific network.
In a real network, with a larger number of network elements, additional managed objects can be required to perform the configurations. In particular, configuration of IP, activation and configuration of dynamic routing protocols (RIP, OSPF) require the use of additional managed objects.
IP over DCC (with proprietary or PPP encapsulation) requires configuring a subnet per link (per DCC). Any network element configured with IP over DCC, and located more than two DCC links away form Cisco Edge Craft must either have a static route to Cisco Edge Craft, or run a dynamic routing protocol. As the number of static routes grows with the number of interfaces configured to run IP over DCC, running a dynamic routing protocol can be advantageous. Note that depending on the network topology, care must be taken when enabling IP routing protocol over DCC to prevent the DCC network from being advertised as a path for the user traffic (as opposed to only the management traffic).
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...