We are having an issue where we are not getting ARP replys from a device connected (126.96.36.199) to an ML card in the field. We have a switch connected to the ML card at the end head. There are 2 VLANs on the switch each with a gateway address, VLAN A 188.8.131.52 VLAN B 184.108.40.206 wich are routing. If I plug into VLAN A I get the ARP back, if I plug into VLAN B I do not. Should I enable IP Route 0.0.0.0 0.0.0.0 POS 0 and POS 1 to make this work.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...