Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

3G-SDI over DWDM

Hi Everyone,

Our system is a point-to-point 15454 ONS MSTP. Our cards are AR-XPs licensed for MXP-VD-10G. The software release is 9.4. In our first node 1 AR-XP have 3 ONS-SC-HD3GV-TX on ports 1-3, on the other node our AR-XP have 3 ONS-SC-HD3GV-RX on ports 1-3, both have trunks on port 9. All the PPMs in ports 1-3 can only be configured as SDI_3G_VIDEO. In our testing, we created an OCHCC circuit with SDI_3G_VIDEO size on port 1 between the two nodes. We tried to pass SD-signal and HD-signal traffic but only the SD-signal video was successful. We also noticed that even though our SFPs should be configurable as SD-SDI, HD-SDI, and 3G-SDI, we can only configure them as 3G-SDI. In our 3G-SDI circuit, is it possible to pass HD-SDI?

We tried to find procedures for this in our manuals and procedure guides but couldn’t find any. Are there any settings that we need to set in our configurations for the trunk or circuit? Any presentation for the step by step configuration will help.

Thanks!

743
Views
0
Helpful
0
Replies