Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Asking about Acceptance Test Plan

I need information about Acceptance Test Plan for a product backbone. In that product exists some ports for some services, those are Gigabit Ethernet ports, E1 ports, OC-3 ports,10/100 BT port.

I still don't understand about parameter in those ports. What parameters

should be measured in ATP prosedure.

1 REPLY

Re: Asking about Acceptance Test Plan

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

367
Views
0
Helpful
1
Replies
CreatePlease to create content