I am new to 454's and am bringing up five new ones, they are in place already with OC192s connecting them. My questions are what is the best practice for implementation, I have only IP access to one of them and the rest should be able to be seen via light, but I dont see them, also I cant seem to get CTC running when I go to run CTC on the one that I can see by IP the grey block comes up then the Black DOS window comes up, the Black DOS windwow goes away and the solid grey block has only a grey outline and there it stops. can anyone help me?
Have you turned up DCC on your high speed links? Have you configured the static routes? The "gateway NE has a router gateway IP and the "slave" nodes do not have router gateway IPs? The computer you are trying to reach them with is on the same network you have static routes configured for? If everything is correct and the problem persists, reboot the TCC cards one at a time (give some time between reboots) on the node that is unreachable, and then on the gateway if all the slave nodes are unreachable.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...