Re: Can Policy Routing be configured on the RPR interface?
Are you applying the config on the DPT interface or the Ethernet interface? I'd be suprised if you could configure any policy routing on the DPT interface. Rather I would have thought it should be applied on the Ethernet interfaces involved in the connection. Bear in mind that the router function of the 10720 does not really see the DPT ring, but as logical point to point links.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...