Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 15305+E100-WAN-8

Hi.

I just received two Cisco 15305 and E100-WAN-8 modules. For now I need to do a simple scheme. cisco's 15305 connected between each other through optical fiber

I have two laptops connected to E100-WAN-8 module with both sides. I just need that laptops to ping each other.

please help!

ps

sorry for my bad English

3 REPLIES
New Member

Re: Cisco 15305+E100-WAN-8

I don't ask complete istruction how to do that..at least some basic steps, please.

ps

and I fogot to say about optical module

STM-4 L4.2-2-LC through which 15305 connected

New Member

Re: Cisco 15305+E100-WAN-8

ok. point-to-piont connection is work on layer 1. But in the end I need Point-to-Multipoint Ethernet Connection.

Here is the theory - http://www.cisco.com/en/US/products/hw/optical/ps2001/products_white_paper09186a008021dea6.shtml

But how practicaly to do that? I need something like in Figure 4.

New Member

Re: Cisco 15305+E100-WAN-8

The easiest is to configure a L1 circuit.

Set the Eth port to L1. This will provide access to configuration of the VCG for Ethernet over SDH services.

375
Views
0
Helpful
3
Replies
CreatePlease login to create content