07-08-2008 10:55 PM
Hi.
I just received two Cisco 15305 and E100-WAN-8 modules. For now I need to do a simple scheme. cisco's 15305 connected between each other through optical fiber
I have two laptops connected to E100-WAN-8 module with both sides. I just need that laptops to ping each other.
please help!
ps
sorry for my bad English
07-09-2008 04:10 AM
I don't ask complete istruction how to do that..at least some basic steps, please.
ps
and I fogot to say about optical module
STM-4 L4.2-2-LC through which 15305 connected
07-10-2008 09:33 AM
ok. point-to-piont connection is work on layer 1. But in the end I need Point-to-Multipoint Ethernet Connection.
Here is the theory - http://www.cisco.com/en/US/products/hw/optical/ps2001/products_white_paper09186a008021dea6.shtml
But how practicaly to do that? I need something like in Figure 4.
12-12-2008 02:25 PM
The easiest is to configure a L1 circuit.
Set the Eth port to L1. This will provide access to configuration of the VCG for Ethernet over SDH services.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide