Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco Metro 1500 2R/3R Question

We are configuring a Metro 1500 with several WCMs for different applications. Our customer has asked us to provide 3R on all interfases. We have included a LST fot an OC-3 link (MM fibre). We know that the LST and HST only support 2R.

Are there plans to support 3R on these interfases? Or they just do not support it because of the variable data rate?

Regards,

Cesar Quinto

cquinto@pe.ibm.com

2 REPLIES

Re: Cisco Metro 1500 2R/3R Question

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you, or there is no public information available at this time. If you don't get a suitable response to your post, you may wish to review our resources at the online http://www.cisco.com/go/solutions. You may also contact our product information line at 1-800-553-NETS or a Cisco Systems Engineer at your local Cisco office or reseller. To locate your local Cisco representative, visit http://www.cisco.com/warp/public/687/Directory.shtml

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

New Member

Re: Cisco Metro 1500 2R/3R Question

The Metro 1500 supports 3R (signal retime, regenerate and reshape) only on OC12, OC48 and clocked Gigabit Ethernet WCM modules.

OC3 and a wide range of other transponder modules are supported in the ONS 15540 Extended Services Platform. See the data sheet below:

http://www.cisco.com/warp/customer/cc/pd/olpl/metro/on15500/on15540/prodlit/15540_ds.htm

213
Views
0
Helpful
2
Replies
CreatePlease to create content