Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco XENPAK - HP2910 10GB interface

Hi,

We need to connect a Cisco XENPAK-10GB-LR module with a "HP ProCurve 2-Port 10-GbE SFP+ al Module (J9008A)" (a module inside a

"HP Switch E2910-48G al(J9147A)")

The HP switch module would have an "HP X132 10G SFP+ LC LR Transceiver (J9151A)".

Where can I find some info if this kind of fibre connection is supposed to work ?

The specifications for both the devices (XENPAK and the HP module/tranceiver) are same - 10GBASE-LR (single-mode fiber, 1310 nm).

Regards,

Florin

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions

Cisco XENPAK - HP2910 10GB interface

Yes, the two transceivers will interoperate. 

Make sure you order the correct singlemode fiber patch cords to interface to the LC/UPC connector type on the HP transceiver and the SC/UPC connector type on the XENPAK.

1 REPLY

Cisco XENPAK - HP2910 10GB interface

Yes, the two transceivers will interoperate. 

Make sure you order the correct singlemode fiber patch cords to interface to the LC/UPC connector type on the HP transceiver and the SC/UPC connector type on the XENPAK.

971
Views
0
Helpful
1
Replies