Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CTC Management Network Connectivity

I have about 60 15454s and I am using the RIP tables with SOCKS only enabled at 7 nodes to segment the CTC traffic for improved response. I will have LAN access at every node soon. As I transition over and set the gateway address at my new LAN access nodes, the CTC traffic still prefers to use the SDCC rather than the LAN connection. I see the direct LAN connection to my nodes using a tracert from my CTC laptop but the Netwrok Routing Table from the nodes and delayed CTC response indicates CTC is using the SDCC.

How do I transition to every node having LAN connections?

Angie

1 REPLY
New Member

Re: CTC Management Network Connectivity

RIP is based on a hop count irespective of whether there is a better higher bandwidth route available so with RIP the route with the least hop count will always be selected, personally I would look at implementing OSPF instead as this uses the available bandwidth as part of the calculation to select a route and you may find it works better in your network. I'm not sure why you need to have LAN access at every node, this seems to be a bit of an overkill and is not really necessary if you have 2 SDCC links into each node.

253
Views
0
Helpful
1
Replies