Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Diagnostic Monitoring is not implemented

Hi All,

We are trying to find the reason and solution for the below problem. We are tring to perform the below command and get the below message.

router#show interfaces gigabitEthernet 5/1 transceiver

Diagnostic Monitoring is not implemented.

The module on which the above gig interface is WS-X6408A-GBIC and the IOS version running on this router is s72033-advipservicesk9_wan-mz.122-18.SXF11.bin. The sup on this router is SUP-720-3BXL.

Any help to understand why it is giving that message and the solution to overcome the same would be really appreciated.

Regards

Anantha Subramanian Natarajan

WS-X6408A-GBIC --Module 5

s72033-advipservicesk9_wan-mz.122-18.SXF11.bin

SUP-720-3BXL

3 REPLIES

Re: Diagnostic Monitoring is not implemented

Which GBIC optical modules are you installing into the WS-X6408A-GBIC? The following document outlines the DOM support by hdwe and software.

Cisco Digital Optical Monitoring Compatibility Matrix

<http://www.cisco.com/en/US/docs/interfaces_modules/transceiver_modules/compatibility/matrix/OL_8031.html>

New Member

Re: Diagnostic Monitoring is not implemented

Hi baileyshbr,

Thank you very much and I have to check the GBIC's .

Regards

Anantha Subramanian Natarajan

New Member

Diagnostic Monitoring is not implemented

s-01-pnh-asr#sh interfaces gigabitEthernet 0/25 transceiver detail

Diagnostic Monitoring is not implemented.

Can't see anything.

11838
Views
9
Helpful
3
Replies
CreatePlease login to create content