i have a situation like 6500 g0/0--- gig(mux)FIBER------- FIBER(mux)Gig----G0/0 6500. only l2 traffic, i want the GigE interfaces to shut down if the fiber is cut & the GigE shuld and come up dynamically if the fiber is up again.
Is udld aggressive is the only option, shud dtp auto negotiation shuld be enabled..
You can probably set up a GRE tunnel between the two devices, and track that.
If any portion of the span goes down, the GRE tunnel will drop (set whatever action you want to happen), and when it comes back up, it should generate another trap and you can do whatever other action you'd like to happen.
I am also looking for same solution. Would like to share that i also tryed with UDLD feature but unfortunetly it is not helping. Because by default udld recovery time is 300 sec(5 minutes). After 5 minutes the same will again recover and then again go into error disable state which will create a flapping like of scenrio.
Its better not to go for UDLD, But still if you find any permanent solution for this problem. Kindly do inform me.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...