Consider this case 1 got 3 sites with DWDM equipment namely A, B and C say I deployed 15252 for A and C then B with 15201 and all the CLIP configured for fiber protection of certain value 50/50, 90/10 etc, refer ditext diagram below
A -> B -> C
Say one day I'd like to put 1 more site say D in between A and B, what would be the impact, putting aside disruption of services between A and B? my questions ?
1. That fiber protection ratio? what does it mean?
2. Would that interfere with fiber protection split parameters on the CLIP on existing A and B DWDM box? If it is what am I going to do with it?
Also referring to same case site A -> B -> C, if site B could not be ready on-time but the fiber is already there, and I want to proceed with connecting site A and C direct (point-to-point) by doing some patching n fiber termination at site B,
1.can it be done, referring to the split ratio? what would be the impact?
2. If not, that does that mean that DWDM installation must be done in sequences with regard to site adjacencies?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...