09-11-2006 09:55 AM
Has anyone had any experience/problems using a Free Space Optics Laser to connect a Cisco switch using CatOS and Cisco switch using IOS software? I have a Cisco 6020 switch with CatOS and Cisco 4506 switch with IOS and cannot get the link lights to come up on either switch.
09-13-2006 02:16 PM
A link light would usually indicate a physical layer problem.
Have you tried a crossover cable (or crossover dongle)?
If you plug a PC directly to the laser transceiver, does the PC see the link as Up?
For a crossover, you should swap pins 1&2-->3&6 (basically exchange the orange and green wires on one end of the cable).
Good Luck
Scott
09-20-2006 08:30 AM
Thanks for everyone's help. At the moment, the MRV guys and the Tmac consulting people who setup the FSO units said there is a problem with one of our FSO heads. We'll see how it goes when they install the replacement.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide