We are trying to bundle two STM-4 on ML-1000-2 Card residing inside Cisco ONS 15454 at both ends to achieve 1.2G. The ONS software version is 7. We tried using RPR (SPR), Link aggregation using POS channel. All sort of other configuration from Cisco web site did not work. We are able to bundled the interface using RPR but the traffic goes out on POS0 and return on POS1. When we use POS channel, the Port-channel bundled the two POS but only one POS interface carries traffic and not both at the same time.
Has anyone successfully tries out this scenario before, please help.
It sounds like you are trying to balance the traffic between two ML cards connected together
ML POS0----POS1 ML
ML POS1----POS0 ML
On the ML cards the traffic that comes in on a port-channel and is flooded to the RPR will all go out only one POS port (not load-balanced). The POS port selection is based on the mapping of member-0 of the port-channel, which can vary when ethernet ports change state.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...