06-20-2014 11:17 AM
Hi
I am beginner, we bought a cisco 2960 X-series switch model no WS-2960-24TS-L and we bought SFP fiber module, how can i configure the sfp module. help me with the configuration commends. when i run sh int gi1/0/25 capabilities it gives the type 1000BaseSX, but when i run sh int gi1/0/25, the gi1/0/25 is down, line protocol is down(not connected). The other end of the fiber connected with sfp fiber modules to srw2024-k9-eu switch.
06-22-2014 01:41 PM
Hi
You must use media-type command & set the port type to sfp.
configure the media-type with this command.
media-type configuration example:
interface Gigabit0/0
media-type rj45 (UTP)
interface Gigabit0/0
media-type sfp (fiber)
06-23-2014 08:23 AM
Hi ReZa Gorjizadeh,
Thanks for your help, how can i enable the other end switch (model no srw2024-k9-eu) it also have same sfp fiber module.
06-23-2014 03:20 PM
Hi
follow these steps :
1- goto Port Management > Port Settings
2- click the Detail button of the appropriate port
06-24-2014 12:16 AM
Hi
i am getting this error when i am trying to set the port (in 2960 switch)
Catalyst(config-if)#media-type sfp
^
% Invalid input detected at '^' marker.
06-24-2014 02:39 AM
my mistake. you dont need the media-type command. recheck you connections and it will be ok.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide