Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

needed sfp fiber module configuration in 2960 x series switch

Hi

 I am beginner, we bought a cisco 2960 X-series switch model no WS-2960-24TS-L and we bought SFP fiber module, how can i configure the sfp module. help me with the configuration commends. when i run sh int gi1/0/25 capabilities it gives the type 1000BaseSX, but when i run sh int gi1/0/25, the gi1/0/25 is down, line protocol is down(not connected). The other end of the fiber connected with sfp fiber modules to srw2024-k9-eu switch.  

Everyone's tags (1)
5 REPLIES
New Member

Hi You must use media-type

Hi

 

You must use media-type command & set the port type to sfp.

 

configure the media-type with this command.

media-type configuration example:


interface Gigabit0/0
 media-type rj45 (UTP)

interface Gigabit0/0
 media-type sfp (fiber)

New Member

Hi ReZa Gorjizadeh,    Thanks

Hi ReZa Gorjizadeh,

 

   Thanks for your help, how can i enable the other end switch (model no srw2024-k9-eu) it also have same sfp fiber module.

New Member

Hifollow these steps :1- goto

Hi

follow these steps :

1- goto  Port Management > Port Settings 

2- click the Detail button of the appropriate port  

New Member

Hi i am getting this error

Hi

 i am getting this error when i am trying to set the port (in 2960 switch)

 

Catalyst(config-if)#media-type sfp
                                    ^
% Invalid input detected at '^' marker.

New Member

my mistake. you dont need the

my mistake. you dont need the media-type command. recheck you connections and it will be ok.

 

 

4739
Views
0
Helpful
5
Replies
CreatePlease login to create content