NM-1A-OC3MM & 3640

[meerz]

I have a 3640 router installed with NM-1A-OC3MM. I upgraded the IOS and the new one is (C3640-I-M), Version 12.3(19), RELEASE SOFTWARE (fc2).

ATM interface is showing in IOS. Do I need a right IOS. If yes than which one.

Regards

[meerz]

Correction for above email

ATM interface is not showing in IOS.

[andrew.burns]

Hi,

You need an "IP PLUS" image for this mod. Looks like you're running IP-only.

HTH

Andrew.

[spremkumar]

Hi

In addition to Andrew's comments you can always refer the below link to find out the ios code with the features you require to have in your box..

http://tools.cisco.com/ITDIT/CFN/jsp/index.jsp

regds

[CSCO10892433]

Here is another page regarding this Network Module:

http://www.cisco.com/en/US/products/hw/routers/ps274/products_data_sheet09186a0080091b88.html

There is a table(Taqble 1) listing the ios version and feature set required.

Regards

SSLIN