Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

non-linear behavior of input errors on 7500 POS interface

Though the input packet error rate on our 7500 POS interface

(PA-POS-2OC3 on VIP6-80) is not very high (between 1 in 50000 /

1 in 250000 packets), it used to be zero until a few

weeks ago.

Then, input errors appeared but in a non-linear way:

as long as the input rate does not exceed 40 Mbps

we are hardly seeing any input erros, but then

the input error rate suddenly increases --

in other words, we see a non-linear behavior of the

input (packet) errors versus received packets.

As to the type of input errors: we don't see CRC

or framing errors so to me looks it's not related

to the SDH network. There's quite a few "abort"

errors (less than 50%) and the rest of the errors

are not identified.

We have similarly configured 7200s/7500s at the other

side of the STM-1 circuit.

Any ideas about the cause or further troubleshooting?

We can open a TAC case but I wonder if 1 in 50000

is high enough an error rate to really wonder.

Thanks,

Patrick

134
Views
0
Helpful
0
Replies