Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

online 10-DME wavelength modification

Is it possible to change the wavelength configured in 10-DME module without disabling or deleting the active circuits? If so, how can this be done? thanks

Everyone's tags (1)
2 REPLIES
New Member

online 10-DME wavelength modification

No, the trunk port must be OOS to change the wavelength.  And if you have the circuits provisioned as OCHCC, you probably have to delete the circuits and trail since these are all logically provisioned to a given wavelength.  And you'll probably need to delete and rebuild internal patchcords, which requires that no circuits/trails are provisioned to the port.

If you only have an OCHNC, you should be a little better off, but in this case, you wouldn't have provisioned circuits or internal patchcords anyway. 

New Member

online 10-DME wavelength modification

thanks for the clarification william....

496
Views
0
Helpful
2
Replies
CreatePlease to create content