Hopefully someone can help sort out an issue we are seeing on only some locations.
With the OC192 Any Reach Card using an ONS-XC-10G-S1 - we are occasionally getting LO-LASER TEMP which is Equipment Low Laser Temp
Issue is that in reading Cisco alarm guide for ONS it shows that this alarm is for the TXP and MXP line cards which have fixed DWDM lasers not pluggables. So when it says to goto PPM Performance and look for laser temp - this is not one of the values?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...