I am new on cisco optical, kindly help me below. Currently we have a requirement to provide one of our customer an STM-4 IP Transit connection, For that we are getting an STM-4 from an SDH device (Ciena CD) direct to us and here (between our upstream and customer) we would like to use our ONS MSPP and deliver the same circuit to customer IP equipment.
How can we deliver the circuit using our ONS device. Shall we cross connect STM-4 SDH -••àSTM-4 SDH interface and deliver. Also we need to check the performance of the circuit as well.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...