Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

ONS 15454 MRC 2.5G4

Hi All,

We are trying to install the optical multirate card (MRC 2.5Gig) on ONS 15454 and found the card comming up on standby state instead of active. The version running on the sonet box is 8.5.0 ...The MRC card port 1 is installed with the OC3 SFP's but cable not attached.

Any help would be appreciated .

Regards

Anantha Subramanian Natarajan

1 ACCEPTED SOLUTION

Accepted Solutions
Bronze

Re: ONS 15454 MRC 2.5G4

Hi, this is normal. Just go on and enable a SFP, called pluggable port module (PPM). After the first SFP is enabled, the state of the MRC card will change to working.

Cheers

Rene

2 REPLIES
Bronze

Re: ONS 15454 MRC 2.5G4

Hi, this is normal. Just go on and enable a SFP, called pluggable port module (PPM). After the first SFP is enabled, the state of the MRC card will change to working.

Cheers

Rene

New Member

Re: ONS 15454 MRC 2.5G4

Hi Rene,

Thank you very much ...We were able to do that .

Regards

Anantha Subramanian Natarajan

212
Views
0
Helpful
2
Replies