Is port 9 on the 10DME card up at both ends? What FC speed are you trying to configure? What mux/demux cards are you using? I suspect there is a problem with the patching between the 10DME Port 9 and the Mux/Demux card(s) channel ports. Also check that the Wavelength Trunk setting is configured to the correct wavelength and that it is connected to the correct port on the mux/demux card(s). If the patching is correct then check that the power levels are correct, look under the Performance tab for each card. Once port 9 on the 10DME card is up you should have no problem creating an FC circuit.
To configure the card is straightforward first make sure the mode (under Provisioning>Card) and the PPM (under Provisioning>Pluggable Port Module) are correct for the type of FC your configuring. Hope this helps
We were creating an OCHNC connection between the 10DME cards, then trying to create the FC OCHCC. The OCHNC would come up fine but the OCHCC kept failing with an error about an internal patch cable missing at the destination end. Turns out that the CTC wizard cannot set up the OCHTRAIL circuit if an OCHNC circuit is already built for that wavelength. We deleted the OCHNC then created the OCHCC and everything came up fine.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...