Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Product options for OC48 laser

I am looking for a 1310nm IR OC48 but I am having trouble figuring out what options Cisco provides that fit this qualification.  I apologize if this is the wrong forum for this type of question.  If so, and there is a right forum, if you would point me to it I would be grateful.

11 REPLIES

Re: Product options for OC48 laser

What hardware is this oc48 being installed in?

Sent via BlackBerry by AT&T

New Member

Re: Product options for OC48 laser

It's being put into a CISCO 15454

New Member

Re: Product options for OC48 laser

Previously an ONS-SE-Z1= and an ONS-SI-155-i1 have been used, but I'm not clear on the differences, other than the 155 being much less expensive.

Re: Product options for OC48 laser

The 155 is OC3

Sent via BlackBerry by AT&T

New Member

Re: Product options for OC48 laser

Thanks - I should have caught that.  So the ONS-SE-Z1= is ok?  Are there other options or is this the one.  Thank you again Tom.  I really appreciate the help.

Re: Product options for OC48 laser

I am stuck in snow traffic on crackberry. Look at the 15400 reference guide online.. I believe it has a x-ref table by intf card

Sent via BlackBerry by AT&T

New Member

Re: Product options for OC48 laser

Thanks.  Stay safe.  Looked at the guide and didn't see it - I'll keep looking around.

Re: Product options for OC48 laser

Does lhis doc help. Hard to view on phone.

http://m.mcisco.com/pocket.paper?url2=http%3a%2f%2fwww.cisco.com%2fen%2fUS%2fprod%2fcollateral%2foptical%2fps5724%2fps2006%2fbrochure_c02-452560.html

Sent via BlackBerry by AT&T

New Member

Re: Product options for OC48 laser

I'm still looking through it, but this looks like it has what I needed.  Thanks again! 

Re: Product options for OC48 laser

Here is the document I was looking for. 

http://www.cisco.com/en/US/docs/optical/spares/gbic/guides/ppms2.html#wp203291

You just need to know what card you are installing the transceiver in. 

Good luck.

New Member

Re: Product options for OC48 laser

Thanks again Tom.  This got me what I needed. 

643
Views
0
Helpful
11
Replies