Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

SFP validation failed

We have a Cisco Nexus 4000 switch with the following transcievers and I can't get a link to other 850 nm, sr,  mm interfaces.

sho interface ethernet 1/15 transceiver

Ethernet1/15

    sfp is present

    name is FINISAR CORP.  

    part number is FTLX8571D3BCL  

    revision is A  

    serial number is AL404N7        

    nominal bitrate is 10300 MBits/sec

    Link length supported for 50/125um fiber is 82 m(s)

    Link length supported for 62.5/125um fiber is 26 m(s)

    cisco id is --

    cisco extended id number is 4

hchassis# sho int eth1/15

Ethernet1/15 is down (SFP validation failed)

  Hardware: 1000/10000 Ethernet, address: 0027.0d24.305e (bia 0027.0d24.305e)

  MTU 1500 bytes, BW 10000000 Kbit, DLY 10 usec,

     reliability 255/255, txload 1/255, rxload 1/255

  Encapsulation ARPA

  Port mode is access

  full-duplex, 10 Gb/s, media type is 10g

  Input flow-control is off, output flow-control is off

  Rate mode is dedicated

  Switchport monitor is off

  Last link flapped never

  Last clearing of "show interface" counters never

  1 minute input rate 0 bits/sec, 0 packets/sec

  1 minute output rate 0 bits/sec, 0 packets/sec

  Rx

    0 input packets 0 unicast packets 0 multicast packets

    0 broadcast packets 0 jumbo packets 0 storm suppression packets

    0 bytes

  Tx

    0 output packets 0 multicast packets

    0 broadcast packets 0 jumbo packets

    0 bytes

    0 input error 0 short frame 0 watchdog

    0 no buffer 0 runt 0 CRC 0 ecc

    0 overrun  0 underrun 0 ignored 0 bad etype drop

    0 bad proto drop 0 if down drop 0 input with dribble

    0 input discard

    0 output error 0 collision 0 deferred

    0 late collision 0 lost carrier 0 no carrier

    0 babble

    0 Rx pause 0 Tx pause

  0 interface resets

I have attached the sho run all output. Any idea why I can't get an link out of this? Thank you very much for your time.

2 REPLIES

SFP validation failed

Is the SFP installed in the device a Cisco labelled product or a third-party labelled device?  Cisco SW runs a check to verify the SFP is compatible before allowing it to operate. 

New Member

SFP validation failed

I am assuming even thought the website claims that the FTLX8571D3BCL is Cisco compatible, that it is not. And the

"sho interface ethernet 1/15 transceiver" repsonse "cisco id is --" is proof of that?

I saw some other FTLX8571D3BCL online that had -cs added to the model number. I am guess this difference in model number has caused our failure? I have no clue. All I know is it won't link.

Nowhere on the device does it say Cisco. Thank you.

9346
Views
0
Helpful
2
Replies