I upgraded my Sonet 1545 this morning. The upgrade looked good. I was able to download, install and activate the software. I rebooted the ONS and now It will not boot. The lights just blink. I am not that well versed in this to determine how to get the system back. I see that there are flash cards on the main boards but I am not sure how to proceed
I had a similar situation on the Cisco ONS 15454 MSTP.
I hope you did save the database from NE.
You can try connect to ONS Control Cards vi console RS-232 port and see any message about error.
The RS-232 port is used to connect to the Transaction Language 1 (TL1) management interface. In TL1
mode, the RS-232 port runs at 9.6 Kbps without any flow control. Unlikely to help.
Or install this control card (TCC2,TCC2P, TCC3..) from your node into another node how standby card. Active card do procedure format standby card.You get working standby control card. Then do similar procedure for 2-nd card and
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...