Supervisor Engine 6-E (WS-X45-Sup6-E) configuration for 10G and 1G connectivity

[peter-karichu]

Hi Community,

I need to confirm something.

With the WS-X45-Sup6-E supervisor engine, is it possible to use one of the uplink ports with the X2 optics for 10G speeds and the other port with a Cisco Twin Gigabit Converter Module so as to have 2 1Gb ports?

Or does it only work with 2 10Gb or 4 1Gb only?

Thanks,

Peter

[Marvin Rhoads · Accepted solution]

Sorry but you can't mix and match on the Sup 6. There's a single stub ASIC inside the card which causes this limitation.

The configuration guide explains it here.