Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Supervisor Engine 6-E (WS-X45-Sup6-E) configuration for 10G and 1G connectivity

Hi Community,

I need to confirm something.

With the WS-X45-Sup6-E supervisor engine, is it possible to use one of the uplink ports with the X2 optics for 10G speeds and the other port with a Cisco Twin Gigabit Converter Module so as to have 2 1Gb ports?

Or does it only work with 2 10Gb or 4 1Gb only?

 

Thanks,

Peter

  • Optical Networking
Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Silver

Sorry but you can't mix and

Sorry but you can't mix and match on the Sup 6. There's a single stub ASIC inside the card which causes this limitation.

The configuration guide explains it here.

1 REPLY
Hall of Fame Super Silver

Sorry but you can't mix and

Sorry but you can't mix and match on the Sup 6. There's a single stub ASIC inside the card which causes this limitation.

The configuration guide explains it here.

804
Views
0
Helpful
1
Replies