For this discussion I have two nodes. One 7206 off of Node A and 2 7206s off of Node B. All 3 routers are in the same subnet. Two circuits from Node A / Slot 17 Ethernet to 2 separate Node B / Slot 1 and 16 G.Ethernet cards for each router.
When both circuits are turned up I get a response from one router off of the Node B routers but not the other. I swapped cards and cables at the B end so that I know it's not the equipment. There is a BLSR between A and B.
yes, but I think the problem is 15454 side. What I want to know is the type of ethernet card in 15454. There are 3 cards, which work completely different.
G-series cards are point to point, so there is no L2 connection between the two circuits. Has the router A two interfaces for each circuit? But this is impossible, the router could not have two interfaces in the same subnet. So, in this case use two P2P subnets and the router could route between the circuits.
ML cards (or the old E series) have a L2 switch inside. So it's possible to configure the ports in node A in a L2 vlan if the two circuits end on the same card. Or if the two circuits end on different cards, then configure a third cicuit between this two ML (or E series) cards.
spanning tree not checked when creating a circuit should disable the STP on the ports. After circuit creation you can change STP on the port level, but it does the same.
I had in the past also a lot of problems with STP on e-series cards. As I remember it's a good idea to use a new vlan, because this creates sometimes a new STP process. The problem is you can't reload the STP process without reload the TCC, because STP process is running on the TCC.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.