Serial WIC Router 2901

[Igalvarez]

Hi,

I have a question about my Router 2901. I have connected 3 WIC Serial. 2 of them are HWIC-4T. The third one is a HWIC-2T.

When I do a "Show Interface Se0/2/0"it says "Hardware is WIC MBRD Serial"

Then on the other 2 says "Hardware is HWIC-Serial"

And physically on my router I see "conn leds" light up ont my HWIC-4T Slots but not on my HWIC-2T slot.

Can someone help me? Thanks a lot.

[kayukovvalera]

It seems that third card is not HWIC, but WIC. Please provide us show inventory.

[Igalvarez]

#sh inventory

NAME: "CISCO2901/K9 chassis", DESCR: "CISCO2901/K9 chassis"

PID: CISCO2901/K9      , VID: V06 , SN: FTX170281G2

NAME: "High Speed Wan Interface Card with 4 serial ports(HWIC-4T) on Slot 0 SubSlot 0", DESCR: "High Speed Wan Interface Card with 4 serial ports(HWIC-4T)"

PID: HWIC-4T           , VID: V03 , SN: FOC1752208L

NAME: "High Speed Wan Interface Card with 4 serial ports(HWIC-4T) on Slot 0 SubSlot 1", DESCR: "High Speed Wan Interface Card with 4 serial ports(HWIC-4T)"

PID: HWIC-4T           , VID: V03 , SN: FOC1752206Z

NAME: "WAN Interface Card - HWIC Serial 2T on Slot 0 SubSlot 2", DESCR: "WAN Interface Card - HWIC Serial 2T"

PID: HWIC-2T           , VID: V05 , SN: FOC174371TZ

NAME: "C1941/C2901 AC Power Supply", DESCR: "C1941/C2901 AC Power Supply"

PID: PWR-1941-2901-AC  , VID:    , SN: