Other Collaboration Subjects

I was wondering about QOS on a MGCP gateway, as the config the I currently use on the gateway has no QOS commands, Found the link below on the cisco site, which seems to indicate that the CCM instructs the g/w to assign DSCP 46 by default to udp pack...

Looking for an inexpensive (company is cheap) VOIP solution. We have 50 franchise remote offices all with their own PBX systems. We recently installed an MPLS network & all offices have Cisco 1841 routers. (I know, I know, we should have purchased 28...

I need to configure a cisco router to route voice calls between IP phones, i heard that this feature is available in IOS 12.3 using SIP.Thanks in advance.

Hello, I have a question which will interest more professionals: Which are favour and inconveniant of IP phone for end user company? I mean IP phone, video... (visoconference, phone...) I do not think only about data-processing, I also think about...

Hi,Is there a way to check if the PIN and the Extension entered are correct in an ASP script? Any help would be appreciated (and rated) !Cheers,Victor

HIIs there a way to do a csv dump on partition/Calling Search Space. I'm thinking "show config" but not sure which tags to use. Thanks

We are running CCM 3.35, with approximately 2000 phones. The last three times that we have performed phone load updates, we have seen 2-3 phones that would upgrade and then display a "Protol Application Invaid" message. It seems that this problem b...

Hello,The majority of my European locations are currently using some type of DECT phones. I realize that the 7920's are supposed to be the solution for this but there are a few problems with them and in addition there is already a great investment in...

We have recently upgraded our CCM from 4.0.2a to 4.0.2a sr2 and also upgraded our 7912 phone loads to 6.1.0. Since making these changes when we dial a number on the phone and then lift the handset the call is lost, this happens intermittently. Can ...

This link shows all Cisco supported Antivirus for CCM. But it shows CA's eTrust Antivirus 7.0 is only supported on CCM3.33. Our customer has CCM 4.12 and their corprate Antivirus is CA. Has anybody know CA can be running on CCM4.12?http://www.cisco.c...

Can I do LLQ on the interface and LLQ on the queue for the CB shaping on the same interface?

After upgrading the ICS 7750 SPE 310 from 3.1.4b to 3.3.4, i am trying to access the phone directory from the phone and it is asking me for an authentication required, username and password pop up. I already check all the settings and they are the sa...

Despite a couple of hours on CCO, I can't find a list of skinny-supported IP phones. Can anyone point me to one or tell me from their experience?Thanks in advance,Stuart Smith

DND button cannot be used because it is grayed out on the display. Have checked the DND settings - have replaced all settings but still problem is present. Have reset the phone and problem still persists.

Customer is using PA (1.4(5) ) for speech services only. When the customer dials the pilot point to get to the speak by name directory, the system will say "Extension XXXX" or "JOe Smith" (the calling extension or name" before it gets to the PA gree...