Other Collaboration Subjects

have an Cisco MC3810 router with 4 E&M analog interfaces ( Type 5 - 4 wire ) that are connected to an PBX and are configured for use in a VoFr connection.Is it possible to configure a connection like this ( VoFr) changing the 4 E&M analog interfaces...

Hi - We are trying to install CM3.1 and are having an issue with Active directory integration. We have multiple ou's and apparently CM will only see one. Are we just missing something or is this a flaw in CM? Your assistance is appreciated.Thanks, ...

Hello,Could anyone help me out with some basic questions?. If i have some ipphones connected via internet, I don't need PBX if i want to talk only between them,is that right?.Is it possible to develop an application to callanother voice recognition s...

We have Call Manager cluster cisisting Of P, S1, S2(publisher Subcriber-1&2)S1 has phone registered to it and S2 has phones registered to it.How do I configure the Unity server for CCM IP.If I put in the P address, VM does not work.

I am trying to find out how to use my 7660 phone at home over my broadband connection. We have a Pix 525 as our Firewall and VPN. I would like to know if I need additional hardware or just changes in my config. Thanks in advance.

Does anyone have experience in both of these equipments working together ? any problem ? Thanks for any response.Duc Vu

I have a greenfield fiels site that will have 2000 employees. The voice system will be wholly run over VoIP. How many voice lines can each slot in a 6500 take?

Standard Config: [Switch]---802.1q---[Phone]---[PC]Separate VLAN for voice and data.What will happen if, for whatever reason, the IP phone failed. Can the PC bypass the phone automatically? If it does, how does the PC know which VLAN it should go to.

Hello,What IOS can you recomend for AS5300(for VoIP). That it had very few bugs(the ones that are not so important) and was stable.I have read all release notes and I know all the official information about their caveats. So I need your personal oppi...

We have a customer that has sites in Singapore, Taipai, and Shanghai. They will be using FXO’s for PSTN access. Is there anything special I need to know when ordering the FXO cards for these sites? Will the Asian sites use the same FXO used in the...

Anyone seen any problems resulting from changing the Trace Configuration setting for CallManager SDI 3.2? Currently we get a new file every minute or so, which means you may have to look in alot of files to find a particular phone call.Present Settin...

I have 2 Cat4224, and I get a busy tone from all 8 FXS ports.All the ports are up (no shut).I have tried with different cptone setting (us, mx,...)The IOS version I have in one Cat4224 is 12.1(5)YE3 and in the other is 12.1(5)YE5I verified the pin-ou...

Does anyone know if the VIC-2FXO-M1 can be used directly as an equivalent to a VIC-2FXO? It looks like the VIC-2FXO-M1 does reverse lookup - is that caller ID? Any problems buying these instead of the plain FXO's as a future-proofing method when po...

here's my situation. I have a situation where I want a certain DID to go to a particular call handler on my Unity Voice Mail Server. I created a CTI Route Point Extension in CallManager that is setup to forward all calls to the voicemail extension....

Hi.I installed CCC on MCS server without CCM.After install,follwing "Error Message" appear"Cisco Application Engine Couldn't"create service"And unfortunatly, "CRA admin" window can't open.Am I must install CCM?Please tell me.