Other Collaboration Subjects

When I try to login into the callmanger from IE7 I get a mesgage there is a problem with the websites security certificate. I can click continue to website. But I have a Certificate Error next to the address bar. It says Mismatched Address. I can vie...

Hi,In one of our customer's setup the Voice GWs will be in the DMZ zone , and CCM & CRS/IVR server will be in the intranel(LAN) zone.What is the most recommended signalling & Medial protocol which most customers would use across firewalls?thanks

I need to install an automatic attendant, only that I don't have a cisco unityIs there a method to do it? for example with router

Hello. I went through all the documentation and installed everything. I can log into the admin page but am trying to test the MakeACall application and am getting the error in the logs that it cannot place a call to dn 1002. The web page indicates su...

We currently have Call manager 6.1 (linux based) with a Publsher and Subscriber sitting in our cluster. I am attempting to set up a 7940 (2 button) phone in a lobby type area. I want only the two buttonson the phone to work as speed dials would, bu...

Hi There,I have a 2610 router with a VWIC-2MFT-T1 card installed. The IOS is: c2600-jsx-mz.122-46a.binwhen I start the router, I see that the voice card is detected but then when I do a "show run" I do not see any voice port or interface etc. I can c...

Hi all,In our company we have two callmanager Clusters ( Site A 4.1.3 ; Site B 6.1 )Before we did an Upgrade on the one site we could use the directory from the other side as well as our own, but since we did the update the users can only access thei...

Greetings, is it possible to configure a CME system with both an ISDN and SIP connection, Using the SIP Service for the primary source of inbound and outbound calls and have CME failover to the ISDN should the IP Connection to the SIP Proxy fail?I kn...

All,I'm making my first attempt at installing Unified Presence ver 6.0.3 on an ESX 3.5 Guest VM. I'm able to get all the way through the installation up until I get a "Failed to get Trusted-Peer validation" from the CUCM (ver 6.1.2) Primary Node. I'...

Where do I find the timer to change when A all goes into voice mail box and then they hangup. Customer does not want hangup calls in voice mail. Is there anyway change the timner on this?

Hi there,I'm having a problem with one port in an ATA Box, I can receive calls properly from any internal and external phone but when I try to call from the phone connected to port 2 in my ATA I get a busy line signal but the line is available. The p...

Hi! I develop idle service for 7941, everything works fine. But I have problem, users are accustomed to first dial the number on the keypad, then press the call. When the page is displayed on the screen, dial impossible. The keyboard is blocked. Can ...