I have a Cisco 2851 voice bundle. Is it possible to take two VWIC 1MFT-T1 modules and use one for a voice PRI and one for a voice T1 line? I think I read that you couldn't do it with a 2MFT-T1 card but wasn't sure about splitting it up but still on t...
In order to support 161 T1/PRI Channels and 144 T1 CAS/E&M Channels what would be my best options keeping in mind 911 Calls as well. I am leaning towards (4) Cisco 3845 routers in the following Configurations.First 3845 router will have 4-port PRI ...
I have just upgraded to CCM 3.3.5 from 3.3.3sr4 and trying to install MLA 1-2-4a, however it says I have to uninstall MLA 1-2-2 (that I previously had installed on previous version of CM) before I can install the new version, when I try to uninstall ...
Hi i have a problem with 7912s registered to a callmanager v 4.1(3)sr3a. I changed the maximum allowed calls in the directory number but nothing happened, do you think that Cisco release a service release to solve this problem? I don't know what els...
Hi everyone,in the Cisco docs for the config of NIC Teaming in the CM they said that its not a best practice to put the Team in "load Balancing" instead they recommends to put it in "Fault tolerance only", anyone knows why is that?? i wants to do the...
I have a callhandler that transfers a caller to an extension, this works fine internally, when a PSTN caller comes in and unity tries to transfer the call it cuts the caller off, the only way round it is to select supervise transfer option on the cal...
Does anyone know if there is a global setting to make the Restricted setting under the Settings Access on the phone config page not be available? It used to be there (Enabled, Disabled, and Restricted) but now only seeing Enabled and Disabled in the ...
CCM version 4.2.3the 7960 can register with CCM only if CCM enabl auto-registrationthe 7960 can register with CCME without any problemother 7940 can always register wtih CCM without any problemthe 7960 always shown"file not found" and "Registration R...
Now, I'm installing several remote locations with centralized call manager (4.1.3),the remote vocie gatway talk MGCP to centralized CCM with SRST.Now I want to provide simple AutoAttendant by TCl script to remote locations under normal and SRST mode....
Is it possible to play one MOH stream for internal users and another for users that come in through the Gateway (PSTN) I have assigned a device pool to the Gateway with a different MOG stream than that of the phone but I still get the MOH stream from...
