11-11-2006 10:23 AM - edited 03-13-2019 03:45 PM
Hi, need help...
I have problem sending faxes from:
PSTN---E1 PRI---Router H323 2821---VG248 H323 confgured on CCM, not works
But, sending faxes from:
FXO---Same router H323 2821---Same VG248 H323 configured on CCM, works good
I am using fax passtrough global and dial-peer. Any idea?
11-11-2006 11:23 AM
Cristian,
Can you paste your dial-peer configs. at a min you should have,
a. modem passthrough
b. fax rate disable
to disable fax relay and enable fax passthrough.
Under vg248, port settings do the following.
a. disable fax relay
b. disable fax relay ecm
c. override nsf 0000 (setting)
d. set fax passthrough mode to ios mode.
HTH
Sankar
PS: please remember to rate posts!
11-11-2006 01:51 PM
Sankar
Router 2821
!
voice service voip
fax protocol pass-through g711alaw
h323
!
dial-peer voice 701 voip
destination-pattern 701
session target ipv4:172.30.29.1
dtmf-relay h245-signal
codec g711alaw
fax rate disable
fax protocol pass-through g711alaw
!
Cristian
11-11-2006 08:48 PM
Cristian,
The fax protocol pass-through comamnd doesnt work. You need to use the modem pass-trhough command instead.
HTH
Sankar
PS: please remember to rate posts!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide