Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

0 to telco operator

Two questions here about dial plan:

1. 0 to telco operator for call collect.Can I just create a route pattern 0 and then assign it to the voice gateway?

2. I'll have 9.1[2-9]xxxxxx for long distance inside the country and 9.1[2-9]xx[2-9]xxxxxx for long distance to North America.I am cencerning that there will be 10s delay when user try to use the first pattern.

Thanks

  • Other Collaboration Voice and Video Subjects
1 REPLY
Silver

Re: 0 to telco operator

The dial plan you have mentioned is what a typical US dial plan looks like. You can just create a route pattern starting with 0 like 0! and for National dialing the route pattern 9.@ can be used. For more information : check the following documents:

A Typical U.S. Dial Plan for Cisco CallManager 3.x

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a0080094b2a.shtml

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note09186a00800949f0.shtml

86
Views
0
Helpful
1
Replies
This widget could not be displayed.