receptionist's IP phone is configured as muliple lines, in which one is extension 0. User can reach reception if thye press 0 and wait for 15 seconds . However if they press 0 and then #, they get fast busy tone. Is there a way can solve this issue by dial 0# to reach reception. Thanks.
What you could do is to set up a translation pattern for 0# in CCM and set it to discard "Trailing #". The transform mask will also be 0 (but without the #). This should work fine.
Alternatively, you can set this up and totally delete the DN on the phone in question(i.e. 0). You can then set the transform mask to a number on the receptionist's phone more consistent with your internal numbering plan. This may be more acceptable for configuration purposes.
Oops..sorry ,my mistake.I'm just used on all my systems the receptionist is still on the pbx.Guess you don't use 9 (or whatever) for external calls and i'm afraid thats the only way to avoid your problem..
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...