Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

1750 upgrade dsp

I have upgraded an 1750 with PVDM, but cannot get any voice ports, the number of dsp's is 340, that's impossible, isn't it? What's wrong?

System Bootstrap, Version 12.0(3)T, RELEASE SOFTWARE (fc1)

Copyright (c) 1999 by cisco Systems, Inc.

C1700 platform with 32768 Kbytes of main memory

program load complete, entry point: 0x80008000, size: 0x49d520

Self decompressing the image : #################################################

################################################################################

################################################################################

################################################################################

################################################################################

################################################################################

################################################################################

############### [OK]

Restricted Rights Legend

Use, duplication, or disclosure by the Government is

subject to restrictions as set forth in subparagraph

(c) of the Commercial Computer Software - Restricted

Rights clause at FAR sec. 52.227-19 and subparagraph

(c) (1) (ii) of the Rights in Technical Data and Computer

Software clause at DFARS sec. 252.227-7013.

cisco Systems, Inc.

170 West Tasman Drive

San Jose, California 95134-1706

Cisco Internetwork Operating System Software

IOS (tm) C1700 Software (C1700-O3SV3Y-M), Version 12.1(1)T, RELEASE SOFTWARE (f

c1)

Copyright (c) 1986-2000 by cisco Systems, Inc.

Compiled Thu 16-Mar-00 18:12 by ccai

Image text-base: 0x80008088, data-base: 0x808C45B0

cisco 1750 (MPC860) processor (revision 0x501) with 24576K/8192K bytes of memory

.

Processor board ID JAD0427051H (1670707305), with hardware revision 0000

M860 processor: part number 0, mask 32

Bridging software.

X.25 software, Version 3.0.0.

1 FastEthernet/IEEE 802.3 interface(s)

32K bytes of non-volatile configuration memory.

8192K bytes of processor board System flash (Read/Write)

--- System Configuration Dialog ---

Would you like to enter the initial configuration dialog? [yes/no]:

% Please answer 'yes' or 'no'.

Would you like to enter the initial configuration dialog? [yes/no]:

% Please answer 'yes' or 'no'.

Would you like to enter the initial configuration dialog? [yes/no]:

% Please answer 'yes' or 'no'.

Would you like to enter the initial configuration dialog? [yes/no]: n

Press RETURN to get started!

00:00:23: %SYS-5-RESTART: System restarted --

Cisco Internetwork Operating System Software

IOS (tm) C1700 Software (C1700-O3SV3Y-M), Version 12.1(1)T, RELEASE SOFTWARE (f

c1)

Copyright (c) 1986-2000 by cisco Systems, Inc.

Compiled Thu 16-Mar-00 18:12 by ccai

00:00:24: %LINK-5-CHANGED: Interface FastEthernet0, changed state to administrat

ively down

00:00:25: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0, changed

state to down

Router>

Router>

Router>

Router>

Router>

Router>

Router>

Router>en

Router#show diag

Slot 0:

C1750 1FE VE Mainboard Port adapter, 3 ports

Port adapter is analyzed

Port adapter insertion time unknown

EEPROM contents at hardware discovery:

Hardware Revision : 5.1

PCB Serial Number : JAD0427051H

Part Number : 73-3743-05

Board Revision : 50

Fab Version : 04

EEPROM format version 4

EEPROM contents (hex):

0x00: 04 FF 40 00 C9 41 05 01 C1 8B 4A 41 44 30 34 32

0x10: 37 30 35 31 48 82 49 0E 9F 05 42 35 30 02 04 FF

0x20: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

0x30: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

0x40: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

0x50: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

0x60: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

0x70: FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF FF

Packet Voice DSP Module:

Hardware Revision : 2.2

Part Number : 73-6731-01

Board Revision : A0

Deviation Number : 0-0

Fab Version : 03

PCB Serial Number : ICP051700H7

RMA Test History : 00

RMA Number : 0-0-0-0

RMA History : 00

Processor type : 02

Number of DSP's : 340

Type of DSP : TMS320C549

EEPROM format version 4

EEPROM contents (hex):

0x00: 04 FF 40 02 AD 41 02 02 82 49 1A 4B 01 42 41 30

0x10: 80 00 00 00 00 02 03 C1 8B 49 43 50 30 35 31 37

0x20: 30 30 48 37 03 00 81 00 00 00 00 04 00 09 02 FF

WIC Slot 0:

Dual EAM Voice Interface Card WAN daughter card

Hardware revision 1.1 Board revision C0

Serial number 0010377560 Part number 800-02497-01

Test history 0x00 RMA number 00-00-00

Connector type WAN Module

EEPROM format version 1

EEPROM contents (hex):

0x20: 01 0F 01 01 00 9E 59 58 50 09 C1 01 00 00 00 00

0x30: 60 00 00 00 98 09 10 01 FF FF FF FF FF FF FF FF

Router#

1 REPLY
Bronze

Re: 1750 upgrade dsp

Here is a troubleshooting link that should help you:

http://www.cisco.com/en/US/customer/products/hw/routers/ps221/products_tech_note09186a0080094a66.shtml

My first two guesses, because of the DSP count being so high, you may have unsupported DSP's (the 1750's take PVDM-x versus the PVDM-256-x). Second guess would be IOS version is too old.

Rick

227
Views
0
Helpful
1
Replies
CreatePlease to create content